Overview

The Weigh Station Bypass Overview page provides details about Drivewyze PreClear features

Configuration

Fleet Configuration and Default Settings

Current Fleet Configuration, while still under development, can be viewed on the first tab of the Management -> Weigh Station Bypass page.
Setup or Changes to the configuration are currently being processed manually as this page is still under development. Please contact Support for assistance.

 

 

Fleet Image Configuration

A Fleet Image is a picture of the Vehicle which is displayed for Weigh Station Officers to be able to visually identify a specific Vehicle as it either Bypasses or Pulls Into the POE

There are two types of Fleet Image available for you to use

  1. Required: The Fleet Image associated with your Drivewyze Account which is applied to all Vehicles by default
  2. Optional:  Additional Fleet Images which can be applied to Vehicles which do not appear visually the same as the Default Fleet Image

Pictures to use as a Fleet Image should be taken according to the following guidelines:

  • Should be a photo of an actual vehicle (or a reasonable representation of the vehicle).
  • Vehicle is shot at an angle that shows the front and side of tractor from passenger side.
  • Image includes an attached trailer, fleet logo and colors.
  • Photo is taken in good light with clear focus.

Example of Vehicle Placement in the picture:
 

Adding Fleet Images

Fleet Images can be added in the following ways:

  1. The Default picture add to your Drivewyze Account
  2. Additional pictures added to the [Fleet Images] tab 
    - Any Images that you have added will be available for selection when Adding or Bulk Adding Vehicles
    - Any Images which were added AFTER Vehicle(s) were added can be set by Editing each Vehicle desired

Editing Fleet Images

 

- Any Images which are Changed after being assigned to a Vehicle will automatically be applied to each vehicle which is using that Fleet Image record

 

 

Vehicle Configuration

Adding Vehicles

Vehicles can be added in the following ways:

  1. Automatically using the Fleet Default Settings for PreClear and Transponders
    - This occurs when a Driver Logs onto an ELD and the Vehicle has not yet been configured for any Drivewyze features. The Vehicle will be added to Drivewyze using the Default PreClear features and Default Transponders which you have configured. 
  2. Manual addition of a Single vehicle or Bulk addition of many vehicles
    - Single vehicle addition is accomplished by clicking the [add] button at the top right of the data grid on the Vehicles tab
    - Bulk vehicle addition is accomplished by clicking the [bulk add] button to the right of the the tabs

The above options will assist in your overall continual onboarding and management strategy as illustrated in the following table

StrategyFleet ConfigurationPre/Post Vehicle Configuration
Some Features Enabled by default

Fleet configured for

  1. Default PreClear Features set to the Service level desired
  1. Manually add any Vehicles
All Features Disabled by default

Fleet configured to

  1. Default PreClear Features are all "Inactive"
 

 

Editing Vehicles

Vehicles can be edited after being added to Drivewyze in the following ways:

  1. One at a time by clicking on the [edit] button to the left of the Vehicle record
  2. ALL at once using the [bulk edit] button at the right of the tabs
    - Note that [bulk edit] is meant only for changing PreClear Features and Transponder settings

Auditing

 

Drivewyze® is a registered trademark of Intelligent Imaging Systems IncTM.