OverviewThe Weigh Station Bypass Overview page provides details about Drivewyze PreClear features ConfigurationFleet Configuration and Default SettingsCurrent Fleet Configuration, while still under development, can be viewed on the first tab of the Management -> Weigh Station Bypass page. |
|
Vehicle Image Configuration
A Vehicle Image is a picture of the Vehicle which is displayed for Weigh Station Officers to be able to visually identify a specific Vehicle as it either Bypasses or Pulls Into the POE
There are two types of Vehicle Image available for you to use
- Required: The Vehicle Image associated with your Drivewyze Account which is applied to all Vehicles by default
- Optional: Additional Vehicle Images which can be applied to Vehicles which do not appear visually the same as the Default Vehicle Image
Pictures to use as a Vehicle Image should be taken according to the following guidelines:
- Should be a photo of an actual vehicle (or a reasonable representation of the vehicle).
- Vehicle is shot at an angle that shows the front and side of tractor from passenger side.
- Image includes an attached trailer, fleet logo and colors.
- Photo is taken in good light with clear focus.
Example of Vehicle Placement in the picture:
Adding Vehicle Images
Vehicle Images can be added in the following ways:
- The Default picture add to your Drivewyze Account
- Additional pictures added to the [Fleet Images] tab
- Any Images that you have added will be available for selection when Adding or Bulk Adding Vehicles
- Any Images which were added AFTER Vehicle(s) were added can be set by Editing each Vehicle desired
Editing Vehicle Images
- Any Images which are Changed after being assigned to a Vehicle will automatically be applied to each vehicle which is using that Fleet Image record
Vehicle Configuration
Adding Vehicles
Vehicles can be added in the following ways:
- Automatically using the Fleet Default Settings for PreClear and Transponders
- This occurs when a Driver Logs onto an ELD and the Vehicle has not yet been configured for any Drivewyze features. The Vehicle will be added to Drivewyze using the Default PreClear features and Default Transponders which you have configured. - Manual addition of a Single vehicle or Bulk addition of many vehicles
- Single vehicle addition is accomplished by clicking the [add] button at the top right of the data grid on the Vehicles tab
- Bulk vehicle addition is accomplished by clicking the [bulk add] button to the right of the the tabs
The above options will assist in your overall continual onboarding and management strategy as illustrated in the following table
Strategy | Fleet Configuration | Pre/Post Vehicle Configuration |
---|---|---|
Some Features Enabled by default | Fleet configured for
|
|
All Features Disabled by default | Fleet configured to
|
Editing Vehicles
Vehicles can be edited after being added to Drivewyze in the following ways:
- One at a time by clicking on the [edit] button to the left of the Vehicle record
- ALL at once using the [bulk edit] button at the right of the tabs
- Note that [bulk edit] is meant only for changing PreClear Features and Transponder settings
Auditing
Drivewyze® is a registered trademark of Intelligent Imaging Systems IncTM.